Note: Before cleaning and maintaining the product, be sure to cut off the power and water source of the smart toilet.
1. Remove the body cleaner
Holding down the fixing button on the side of the machine and lifting the body cleaner upwards will make the machine disengage from the fixing plate.
* Please do not reverse this product, which may damage the product or cause a fire.
2. Body cleaner and ceramic cleaning
Smart toilet lid cleaning
Wring it dry with a soft moist cloth and then scrub it. If necessary, wipe it with a cloth with some neutral kitchen cleaner, and then scrub with a damp cloth.
* Note: Because it is an electrical product, in order to prevent water entering, do not rinse directly with water. Be sure to dry it with a soft cloth after cleaning.
ceramic cleaner
Use a soft moist cloth to twist it dry and then scrub it. When the ceramic dirt is serious, you can use a special washing solution for ceramics to clean the dirt properly, but you must clean it with clean water and dry the ceramics.
* Note: When cleaning ceramics, please do not use chlorine detergents or acid detergents.
3. Filter cleaning
If impurities in tap water block the filter screen, it will cause poor water inflow and affect the use of the product.
Please clean the filter in the filter regularly. Due to differences in water quality, the cleaning cycle is different. It is recommended to clean or replace the filter element every 6 months.
Turn off the water source before cleaning the filter, then open the filter cover counterclockwise (Figure 1), take out the filter, and rinse the filter with water. Dirt on the surface can be cleaned with a toothbrush if necessary.
After cleaning, tighten the cover clockwise and confirm whether there is any water leakage.
4. Cleaning of spray head
Cleaning of the spray head must be completed under an electrified state. Press and hold the "butt wash" button when you are not seated.
The spray bar will automatically extend and stay for 60 seconds while self-cleaning. Brush the nozzle with a soft cloth or soft toothbrush during this period. After brushing, you can press the Stop button to end the retraction or automatically retract after 60 seconds. (Figure 2)
